This is a Red Level Machine and is unlocked after tool specific training

1. Check chuck key removal before starting
2. Secure workpiece properly
3. Remove chips with brush or vacuum only
4. Never leave chuck key in chuck

1. Oil all ways and sliding surfaces
2. Verify smooth carriage movement
3. Ensure chuck key is not in chuck

1. Wipe down all surfaces
2. Remove all chips
3. Clean and store any tools used
   • Especially the chuck key.

1. Clean and inspect chuck jaws
2. Check belt condition
3. Clean and oil change gears

1. Inspect electrical cables
2. Clean and adjust gibs if needed
3. Check tailstock alignment
4. Level machine