mill_tooling
This is an old revision of the document!
Mill Tooling
Tool Holding
- Spindle taper is Morse Taper 2 (MT2).
- Collets: 1/8“, ?, ?, ? (collets use 3/8-16 imperial drawbar(need to check sizes)
- Cutting Tools
- End Mills (in stock)
- High Speed Steel (HSS)
- 4 Flute
- Center-cutting
- Fly Cutter
- 1/2” shank (use 1/2“ mt2 collet)
- Adjustable diameter: 2.5”-4“ (63mm-100mm)
- Carbide insert (DCMT070204 for steel, DCGT070204 for aluminum & plastic)
- Boring Head
- 1/2” shank (use 1/2“ MT2 collet)
- Adjustment screw dial is 0.002” diameter per division
- Uses 1/2“ shank boring bars
- Drill Chuck
- MT2 shank (Use 3/8-16 imperial drawbar)
Work Holding
- Mill Vise
- 6” jaw width
- 5.9“ max opening
- Vise stop mounted to back of fixed jaw (Stop rod assembly stored in toolbox)
Mill-Specific Indicating
- Indicol-style holder
- Uses a DTI
- Clamps to the spindle nose
- Can be used with tools installed.
- Edge finder
- Can be used in a drill chuck, or a 3/8” collet
- Tip diameter is 0.200“
mill_tooling.1760953100.txt.gz · Last modified: by chris_santacroce