lathe_tooling
This is an old revision of the document!
Lathe Tooling
Tool Holding
- 0XA Wedge-type toolpost on Solid Toolpost Block (Compound slide stored behind lathe)
- 1/2“ max tool shank regular holders
- 3/8” or 10mm diameter boring bar holder
- 1/2“ parting blade holder
Tail Stock Tooling
- Quill taper is Morse Taper 2 (MT2)
- Live center (small and large)
- Drill Chuck (1/2” max drill bit shank)
Work Holding
- 3-jaw scroll chuck
- Inside and Outside Jaws
- 0.080“ min, 4.0” maximum clamping
- 4-jaw independent chuck
- Reversible Jaws
- 0.080“ min, 4.0” maximum clamping
lathe_tooling.1760950417.txt.gz · Last modified: by chris_santacroce