Differences

This shows you the differences between two versions of the page.

--- bambu_lab_p1s [2026/01/10 05:21] – nick_dunne
+++ bambu_lab_p1s [2026/01/10 05:34] (current) – [Maintenance Log] nick_dunne
@@ Line 96: / Line 96: @@
 ====== Maintenance Log ======
-  * __**5/15/2025: General Maintenance**__
+  * __**TO-DO**__
-      * Adjusted Z-Axis belt timing
+      * Update firmware to latest prior to security/authenticator update
-      * Performed mechanical bed tramming
+      * Create QR code label for wiki page
-      * Added desiccant packs to AMS
+      * Print new poop tray
-      * Cleaned bottom of printer and removed excess grease
+      * Print Y-adapter for AMS/external spool use
-      * Ran self-calibration
+      * Run self-calibration
-      * Purged SD card
+  * __**1/10/2026: Service Entry**__
+      * Connected to network
+      * Completed first-time setup and calibration
+      * Connected AMS
+      * Removed stock extruder gears (silver) and replaced with hardened steel gears (black)
+      * Removed stock hotend (grey) and replaced with hardened steel nozzle (black)
+      * Enabled LAN-only mode
+      * Successfully completed multicolor test print with AMS