Differences

This shows you the differences between two versions of the page.

--- bambu_lab_p1s [2026/01/10 05:12] – nick_dunne
+++ bambu_lab_p1s [2026/01/10 05:34] (current) – [Maintenance Log] nick_dunne
@@ Line 1: / Line 1: @@
 ====== Bambu Lab P1S ======
-FDM (fused deposition modleing) 3D printer with AMS (automatic material system) {{ :p1s.png?400|}}
+**Printer Name:** Blob Ross
+FDM (fused deposition modleing) 3D printer with AMS (automatic material system) {{ :p1s.png?350|}}
@@ Line 24: / Line 26: @@
   * Composites (external spool only - no AMS support)
+**Note:** MAKE Roanoke's P1S, Blob Ross, has been upgraded with a hardened steel extruder gear and nozzle.
+This machine has equivalent material compatibility to the X1 Carbon.
 ----
@@ Line 91: / Line 96: @@
 ====== Maintenance Log ======
-  * __**5/15/2025: General Maintenance**__
+  * __**TO-DO**__
-      * Adjusted Z-Axis belt timing
+      * Update firmware to latest prior to security/authenticator update
-      * Performed mechanical bed tramming
+      * Create QR code label for wiki page
-      * Added desiccant packs to AMS
+      * Print new poop tray
-      * Cleaned bottom of printer and removed excess grease
+      * Print Y-adapter for AMS/external spool use
-      * Ran self-calibration
+      * Run self-calibration
-      * Purged SD card
+  * __**1/10/2026: Service Entry**__
+      * Connected to network
+      * Completed first-time setup and calibration
+      * Connected AMS
+      * Removed stock extruder gears (silver) and replaced with hardened steel gears (black)
+      * Removed stock hotend (grey) and replaced with hardened steel nozzle (black)
+      * Enabled LAN-only mode
+      * Successfully completed multicolor test print with AMS