lathe_tooling
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| lathe_tooling [2025/10/24 18:58] – samantha_sullivan | lathe_tooling [2026/03/13 09:31] (current) – chris_santacroce | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====Tool Holding==== | ====Tool Holding==== | ||
| - | * 0XA Wedge-type toolpost on Solid Toolpost Block (Compound slide stored behind lathe) | + | * BXA Wedge-type toolpost on Solid Toolpost Block (Compound slide stored behind lathe) |
| * 1/2" max tool shank regular holders | * 1/2" max tool shank regular holders | ||
| - | * 3/ | + | * 5/ |
| * 1/2" parting blade holder | * 1/2" parting blade holder | ||
| ====Tail Stock Tooling==== | ====Tail Stock Tooling==== | ||
| - | * Quill taper is Morse Taper 2 (MT2) | + | * Quill taper is Morse Taper 3 (MT3) |
| - | * Live center (small and large) | + | * Live center (with interchangeable tips) |
| * Drill Chuck (1/2" max drill bit shank) | * Drill Chuck (1/2" max drill bit shank) | ||
| ====Work Holding==== | ====Work Holding==== | ||
| * 3-jaw scroll chuck | * 3-jaw scroll chuck | ||
| - | * Inside and Outside | + | * Reversible |
| - | * 0.080" min, 4.0" maximum clamping | + | * Remove 2 bolts from each jaw to remove |
| + | * Jaws are numbered, please don't mix them up | ||
| * 4-jaw independent chuck | * 4-jaw independent chuck | ||
| * Reversible Jaws | * Reversible Jaws | ||
| - | * 0.080" min, 4.0" maximum clamping | + | * Unscrew each jaw all the way, flip, reinsert. |
lathe_tooling.1761332290.txt.gz · Last modified: by samantha_sullivan