MAKE Roanoke Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Pantograph Engraver ======
This is a Red Level Tool and requires tool specific training

====General====
  - Verify the pantograph ratio settings match your project requirements
  - Secure the master template firmly to the template table
  - Mark reference points on blanks for alignment
  - Select appropriate holding fixtures for your workpiece
  - Secure the workpiece firmly to prevent movement during engraving
  - Ensure the workpiece surface is perpendicular to the cutting tool
  - Adjust depth settings in small increments
  - Test depth settings on similar material before final engraving
  - Consider multiple passes for deeper engravings
===Before Use===
  - Choose the appropriate cutter type based on material:
    * Carbide for metals and hard plastics
    * High-speed steel for softer materials
    * Diamond-tipped for glass or stone
  - Select the proper cutting angle for your material
  - Verify cutter sharpness before starting
  - Set the correct depth of cut for your application
===After Use===
   - Clean machine after each use
   - Remove all chips and debris
   - Wipe down surfaces
====Maintenance====
===Daily===
  - Check for loose components
  - Check belt for condition and tension
===Monthly===
   - Lubricate moving parts according to manufacturer specifications
   - Check and tighten all fasteners
   - Inspect stylus and cutters for wear