MAKE Roanoke Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Bridgeport Series 1 Milling Machine ======
This is a Red Level Machine and is unlocked after completing tool specific training

==== General Rules ====

**IMPORTANT: Fill spindle oil cup before each use - machine must not be run without proper lubrication**

  - Always use proper workholding (vise, clamps, or fixtures)
  - Check that workpiece and vise are securely mounted
  - Remove chuck key before starting machine
  - Use appropriate speeds and feeds for material
  - Never adjust workpiece while machine is running
  - Keep hands away from rotating cutters
  - Use climb milling only when appropriate
  - Check cutter rotation direction before starting cut
  - Clean table surface and ways after use
  - Never leave tools on machine table
  - Use brush or vacuum to remove chips, never compressed air
  - Keep area around machine clear of obstacles
  - Monitor for excess vibration or unusual sounds

=== Before Use: ===
**CRITICAL: Fill spindle oil cup - machine must not be run without proper lubrication**
  - Oil all ways and leadscrews
  - Check drawbar tightness
  - Verify smooth table movement in all axes

=== After Use:===
  - Wipe down all surfaces
  - Clean table and T-slots
  - Remove all chips
  - Clean and store any tools used

==== Mill Maintenance ====
=== Weekly:===
  - Check belt condition
  - Clean and oil leadscrews
=== Monthly: ===
  - Inspect electrical cables
  - Check gibs and adjust if needed
  - Verify head tram
  - Level Machine