mill_tooling
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| mill_tooling [2025/10/20 13:01] – chris_santacroce | mill_tooling [2025/10/24 18:56] (current) – samantha_sullivan | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | **Mill Tooling** | + | ======Mill Tooling====== |
| - | | + | ====Tool Holding==== |
| * Spindle taper is Morse Taper 2 (MT2). | * Spindle taper is Morse Taper 2 (MT2). | ||
| * 2 Drawbars, 3/8-16 Imperial, and M10x1.5 Metric | * 2 Drawbars, 3/8-16 Imperial, and M10x1.5 Metric | ||
| Line 10: | Line 10: | ||
| * Set Screw in back end for tension adjustment/ | * Set Screw in back end for tension adjustment/ | ||
| - | __Cutting Tools__ | + | ====Cutting Tools==== |
| * End Mills (in stock) | * End Mills (in stock) | ||
| * High Speed Steel (HSS) | * High Speed Steel (HSS) | ||
| Line 27: | Line 27: | ||
| * MT2 shank (Use 3/8-16 imperial drawbar) | * MT2 shank (Use 3/8-16 imperial drawbar) | ||
| - | __Work Holding__ | + | ====Work Holding==== |
| * Mill Vise | * Mill Vise | ||
| * 6" jaw width | * 6" jaw width | ||
| Line 40: | Line 40: | ||
| * Interchangeable Heads Coming soon | * Interchangeable Heads Coming soon | ||
| - | __Mill-Specific | + | ====Mill-Specific |
| * Indicol-style holder | * Indicol-style holder | ||
| * Uses a DTI | * Uses a DTI | ||
| Line 50: | Line 50: | ||
| * Remember to add 0.100" to your measurement, | * Remember to add 0.100" to your measurement, | ||
| - | __Hand Tools__ | + | ====Hand Tools==== |
| * Homunculus Wrench | * Homunculus Wrench | ||
| * 3/4" box-end, 12-point | * 3/4" box-end, 12-point | ||
mill_tooling.txt · Last modified: by samantha_sullivan