Differences

This shows you the differences between two versions of the page.

--- gauge_blocks_pins [2025/10/20 08:10] – chris_santacroce
+++ gauge_blocks_pins [2025/10/24 19:07] (current) – samantha_sullivan
@@ Line 1: / Line 1: @@
-**Gauge Blocks and Gauge Pins**
+======Gauge Blocks and Gauge Pins======
+These are Yellow Level Tools and are unlocked by Metal Shop Orientation
-__Gauge Blocks__
+====Gauge Blocks====
-  * These blocks are yellow tools.
   * The blocks are the length reference for the shop.
   * The length of each block is laser-etched into the side.
@@ Line 16: / Line 16: @@
     * To be used with micrometers, as a relative thickness/width measurement.
-__Gauge Pins__
+====Gauge Pins====
-  * Gauge Pins are also yellow tools.
   * These pins are "minus" pins, meaning they're one or two ten-thousandths of an inch smaller than the number etched on each pin.
   * Gauge pins are generally used to quickly and precisely measure small hole diameters, typically when reaming or boring.