Differences

This shows you the differences between two versions of the page.

--- elec_orientation_guide [2025/05/19 00:28] – created stan_okrasinski
+++ elec_orientation_guide [2025/08/10 18:57] (current) – [Project Storage] stan_okrasinski
@@ Line 13: / Line 13: @@
 For the purposes of this orientation, the lab is the room that contains electronics, 3D printing, and laser cutting. “Electronics” occupies the space from the table the reflow oven is on to the soldering desk. The table in the middle of the lab is communal space, shared by all sections in the lab.
-(TODO: Add a diagram here)
+{{:electronics-lab.jpg?600|}}
 ===== General Rules =====
@@ Line 21: / Line 21: @@
     * If you have a project which requires this, the best place to do this is outside.
   * Electronics does not currently have battery disposal. If you have batteries to dispose, then don’t throw them away at the space.
-    * I plan to have battery disposal at some point, but not yet
+==== Project Storage ====
+Plastic storage shoeboxes are available for project storage. The bins available for project storage are labeled "Project Storage". All space rules must be followed when storing your projects. You must include a project storage label inside the storage bin with your project.
+{{:electronics-proj-store.jpg?400|}}
 ===== Things We Have =====
@@ Line 43: / Line 47: @@
 If there are specific components you need for a project, let me know! If it’s something that’s used a lot, we may be able to stock it. Also, we’re more than happy to accept component donations if you end up with lots of extras after a project.
+=== Project Kits ===
+As available, project kits will be available. Kits are available to space members who would like to do an electronics project, but need some inspiration. There are a few guidelines when using the kits:
+  - Don't harvest parts from a kit for other projects
 ==== Soldering and Repair Equipment ====
@@ Line 63: / Line 73: @@
   * For soldering irons specifically: leave some solder on the tip of the iron when you’re done
     * This helps prevent oxidation on the tips.
+If you're seeking to learn how to solder, [[https://www.youtube.com/watch?v=6rmErwU5E-k|this video]] is a good starting guide.
 ==== Test and Measure Equipment ====
@@ Line 76: / Line 88: @@
 Safe operation of the reflow oven isn’t covered in the general orientation. However, if something unsafe is happening (e.g. the oven is on fire or smoking), everyone is authorized to use the emergency stop switch.