bambu_lab_x1c
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| bambu_lab_x1c [2026/01/10 05:13] – nick_dunne | bambu_lab_x1c [2026/01/16 21:53] (current) – [Maintenance Log] nick_dunne | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Bambu Lab X1 Carbon ====== | ====== Bambu Lab X1 Carbon ====== | ||
| + | **Printer Name:** Printy McPrintface | ||
| + | |||
| FDM (fused deposition modleing) 3D printer with AMS (automatic material system) {{ : | FDM (fused deposition modleing) 3D printer with AMS (automatic material system) {{ : | ||
| Line 87: | Line 89: | ||
| ====== Maintenance Log ====== | ====== Maintenance Log ====== | ||
| + | * __**1/ | ||
| + | * Replaced z-axis idler pulley | ||
| + | * Perform z-axis belt timing procedure | ||
| + | * Trammed build plate | ||
| + | * Cleaned and lubricated z-axis threaded rods, and y-axis rods | ||
| + | * Cleaned x-axis carbon rods with IPA, removed carbon dust | ||
| + | * Vacuumed bottom tray from debris | ||
| + | * Cleaned glass panels | ||
| * __**5/ | * __**5/ | ||
bambu_lab_x1c.1768022017.txt.gz · Last modified: by nick_dunne