Differences

This shows you the differences between two versions of the page.

--- bambu_lab_x1c [2025/04/23 20:13] – [Slicer Setup] nick_dunne
+++ bambu_lab_x1c [2025/05/16 02:35] (current) – [Maintenance Log] nick_dunne
@@ Line 59: / Line 59: @@
   - Set Region
   - Install default profile for the machine you want to use in the "printer" section (it takes a bit to load)
+  - If prompted to install the Bambu Network Plugin, select YES
   - Download the file in "Machine Profile" below
   - Unzip/Extract the downloaded file. You should see a file with the extension .orca_printer
@@ Line 88: / Line 89: @@
 \\
 {{ :generic_petg.zip | PETG Material Bundle}}
+----
+====== Maintenance Log ======
+  * __**5/15/2025: General Maintenance**__
+      * Adjusted Z-Axis belt timing
+      * Performed mechanical bed tramming
+      * Added desiccant packs to AMS
+      * Cleaned bottom of printer and removed excess grease
+      * Ran self-calibration
+      * Purged SD card