Bridgeport Series 1 Milling Machine

This is a Red Level Machine and is unlocked after completing tool specific training

IMPORTANT: Fill spindle oil cup before each use - machine must not be run without proper lubrication

1. Always use proper workholding (vise, clamps, or fixtures)
2. Check that workpiece and vise are securely mounted
3. Remove chuck key before starting machine
4. Use appropriate speeds and feeds for material
5. Never adjust workpiece while machine is running
6. Keep hands away from rotating cutters
7. Use climb milling only when appropriate
8. Check cutter rotation direction before starting cut
9. Clean table surface and ways after use
10. Never leave tools on machine table
11. Use brush or vacuum to remove chips, never compressed air
12. Keep area around machine clear of obstacles
13. Monitor for excess vibration or unusual sounds

CRITICAL: Fill spindle oil cup - machine must not be run without proper lubrication

1. Oil all ways and leadscrews
2. Check drawbar tightness
3. Verify smooth table movement in all axes

1. Wipe down all surfaces
2. Clean table and T-slots
3. Remove all chips
4. Clean and store any tools used

1. Check belt condition
2. Clean and oil leadscrews

1. Inspect electrical cables
2. Check gibs and adjust if needed
3. Verify head tram
4. Level Machine